Except for a couple of times when the units stopped communicating with each other, the system works as per advertisement.
When the inside-house unit loses its status with the garage door unit you simply unplug the DC power from the top of the unit for a second and then plug it back in. The communications resets and works again. 99% of the time it works but that 1% of the time you need to reset the system.
Helpful hints:
Use a clean flat surface to stick the garage door unit. Do not stick it on the door itself...use a metal part close to the edge.
Be careful of inserting the battery correctly. The documentation was a little vague on this point.
Esthetically, it leaves a lot to be desired. They never mention the ugly little antenna wire on the inside-house unit. But...that doesn't negate the usefulness of the system.
Suggestions for improvement:
Make the red LED light a little brighter.
Get more detail about Chamberlain CLDM1 Clicker Garage Door Monitor.When the inside-house unit loses its status with the garage door unit you simply unplug the DC power from the top of the unit for a second and then plug it back in. The communications resets and works again. 99% of the time it works but that 1% of the time you need to reset the system.
Helpful hints:
Use a clean flat surface to stick the garage door unit. Do not stick it on the door itself...use a metal part close to the edge.
Be careful of inserting the battery correctly. The documentation was a little vague on this point.
Esthetically, it leaves a lot to be desired. They never mention the ugly little antenna wire on the inside-house unit. But...that doesn't negate the usefulness of the system.
Suggestions for improvement:
Make the red LED light a little brighter.
!!1 Saved Intel Core I5 Cpu Processors